'CalibrationOp': Unknown element 'outputDNBand'

Microwave Toolbox
#1

toolbox version and operating system: 4.0 on linux

On cmd line mode, the calibration graph choked with this error message:
Error: [NodeId: Calibration] Operator ‘CalibrationOp’: Unknown element ‘outputDNBand’

  1. this does not happen if I use the same graph on GUI mode

  2. So, I removed this line from the graph xml file:
    false
    And it ran.

Why is this problem occuring on the command line mode only. Is my remedy (2) ok? The output calibrated s0 look fine.
Thanks

#2

This was an old parameter which is no longer needed. I’m not sure why it throws this error only for gpt.