I have installed the standalone version of Sen2Cor 2.4.0 within SNAP 5 (The ‘L2A_Process.bat –help’ command had no errors)
After I run Sen2COR in SNAP, I 've got the following error "Process exited with value 2 Finished tool execution in 0 seconds"
I cannot figure out the problem. Could you please give me your help?
It just happened to initially install SNAP in late November when snap 6.0 was not available at the time… so as you may have already figured out I am just a beginner…
I recommend you running Sen2Cor outside SNAP from a command line tool. Then you find out wheter the proclem is coming from Sen2Cor or from SNAP interface. Look also, if there is an old product with the same name from an earlier processing. If, you should delete it before starting Sen2Cor.