Multi_looking, changing colours

Microwave Toolbox Interferometry
#1

Dear all,
I did multi-looking before and my result was good but I do not know when I repeat same process, my result change its color (almost red).
My process:

  1. Open products
  2. Coregister
  3. Form the interferogram
  4. Deburst
  5. Remove Topo Phase
  6. Multi-look
    I did same before and all goes well but I do not know what is the problem now?

Multi looking result before:

error_multilooking_2.jpg1214×540 293 KB

Multi looking result now:
error_multilooking_1.jpg1217×682 377 KB

I did like this;

mulilook-process.png1920×1080 153 KB

#2

I found its solution by myself:joy: . You should not chose any band for this.:relaxed:

#3

GREAT
It is very fine to find out the solution yourself, But did you ask yourself why Multilook’s step is needed in this exact processsing sequence?