S1 TOPS Coregistration "Cannot Create Data Buffer"

[falahfakhri]

Hi,

Please take a look at this

Terrain-Correction: GC overhead limit exceeded

You could try to break it down into two graphs. After mulitlook put the GRD-post processing which just renames the product and changes its product type and write it, then terrain correct as a separate step which is probably the heaviest. Also, update georeference is only intended to update the geocoding in the product similar to terrain correction but keeping the data in SAR geometry and instead creating a pixel geocoding of where the lats/lons would be if the product was terrain corrected. Thi…

Answering your both questions in one the good parameters and the
scrutinize of the result could be checked via the range and azimuth RMSE