Pixel Spacing bug in SAR-Simulation Terrain Correction

[danceb]

Hey there,
with this topic I will pay attention on two problems which occur within the SAR-Simulation Terrain Correction.
The first one was already mentioned by @carlomarin but did not get approached in the further discussion:

Range doppler TC normalization versus not normalization

Moreover in the TC tool there are two strange behaviors of the software: when one inputs the pixel spacing in m and then click the box with the pixel spacing in deg the pixel spacing just input in meter changes (and viceversa). when the dem is smaller than the image you correct the final output has the size of the input image even though you have no values where the dem is not available Thanks for any help

The first fact occurs in the Range-Doppler Correction as well in the SAR-Sim Correction.

A second bug only occurs in the SAR-Simulation Terrain Correction:
A userdefined pixel spacing is not accepted by the input field! After defining a specific value and choosing another tab afterwards (e.g. “5-Write”) the Pixel spacing is reseted to to predefined value.

I would highly appreciate, if a solution could be found really soon.

Thanks a lot!
D.